CZ P10 S/C/F Trijicon RMR Iron Sights-Lower 1/3rd Co-Witness Rear Dovetail (behind optic) Only offered with a fiber front. - Blacked Out Rear/Fiber Front - (Rear Iron Sight is a Glock .360"/.125" wide, Front Iron Sight is P10 .240"/.115" wide) Dawson Precision Glock MOS Fixed Co-Witness Rear Sights. Dawson Precision CZ P10C Fiber Optic Front Sights
CZ Shadow 2 Optics Ready was just announced and now is CZ P-10 C OR on factorys web page. So I plan to buy a P10 OR who it seeam is deeper miiled and I'll pair it with RMR 3.25. For all the searching I have found, there isn't a plate available to actually mount an RMR to the OR model guns.
Mounting Hardware is Included This mount fits:CZ 75 ShadowCZ 75 SP01 ShadowCZ Shadow 2Dan Wesson DWXDan Wesson DWX CompactThis mount does not fit:Shadow 2 OR (Optics Ready) Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Please note: Trijicon recommends the use of a ...
Details. CZC P10 Optic Ready PT1. 8-32 Threaded Hole for the scope manufactures mounting screws For C-More, STS. These are for the cz-usa made in the USA P10 optic ready "Or" pistols only. Also fit Shadow 2 Optic Ready #91251.
Mar 03, 2020 · The sealing grommet on the bottom of the RMR is slightly visible from the side edges of the adapter plate that meets the RMR. This makes me wonder about the quality of the seal between the RMR and plate. To address this, Trijicon suggested I pick up and install a RMR mount sealing plate (I’ve placed an order for one).
The CHPWS CZ P10 adapter plate is the most rugged, reliable, and trusted red dot adapter plate on the market today. Approved for duty use by over 400 Local, State, Federal and US Military units, this adapter While not designed specifically for the CZ Shadow 2 Optics Ready, it works. Read more.
The CZ Optics Ready Plate Kit allows use with Leupold Delta Point Pro, Shield RMS, and J-Point Sights. Simply place the adapter plate onto slide and secure it using the two supplier M3X8 screws. Place your optic onto the plate and follow the manufacturer's mounting specifications.